SOME NEW ASPECT OF LYAPUNOV TYPE THEOREMS FOR STOCHASTIC DIFFERENCE EQUATIONS WITH CONTINUOUS TIME

Some new Lyapunov type theorems for stochastic difference equations with continuous time are proven. It is shown that these theorems simplify an application of Lyapunov functionals construction method.     

灰熔聚粉煤气化炉存在的问题及改进

对灰熔聚粉煤气化炉运行中存在的问题进行了分析、讨论，并提出了解决方案和建议。     

Effect of the particle size ratio on the conductivity of conductor-insulator powder composites: Numerical simulation

A theoretical method for determining the percolation limit and effective conductivity of composites based on polydisperse mixtures of insulator and conductor powders is proposed. The effect of the particle size ratio between the insulator and conductor on the percolation limit and effective conductivity is studied. Numerical simulation of the microstructure, effective properties, and percolation limit in composites is discussed. __________ Translated from Poroshkovaya Metallurgiya, Vol. 46, No. 1–2(453), pp. 31–40, 2007.     

Multiobjective dynamic load-dispatching method for optimal operation of power systems

A new practical method is proposed which gives a quasi-optimal solution of the dynamic load-dispatching problem formulated by a multiconstraint multiobjective optimization problem. Here, the multiple constraints are rate reserve constraints and power flow ones, and the multiple objectives are fuel cost and CO₂ emission. The proposed method is an integration of the following three techniques: (1) “Group Dispatch Scheme,” which is developed by the authors, is used to satisfy a violated constraint easily. This scheme consists of three steps. The first step is to classify all generators into two groups. One is the group which should be more loaded to satisfy the violated constraint, and the other is the should-be less loaded group. The second step is to add some load to the former group, and to subtract the same load from the latter. The third step is to dispatch each group load to each groups generators, respectively; (2) the dynamic load-dispatching algorithm is used which provides, in practical time, quasi-optimal generation trajectories; (3) the conventional weighting parametric method is used to obtain a Pareto optimal solution of multiobjective problems. The effectiveness of the method is clarified by a computer simulation on the actual power system of Kansai Electric Power Company.     

Progress in near-field photothermal infra-red microspectroscopy

Near‐field photothermal Fourier transform infra‐red microspectroscopy, which utilizes atomic force microscopy (AFM)‐type temperature sensors, is being developed with the aim of achieving a spatial resolution higher than the diffraction limit. Here we report on a new implementation of the technique. Sensitivity of the technique is assessed by recording infra‐red spectra from small quantities of analytes and thin films. A photothermomechanical approach, which utilizes conventional AFM probes as temperature sensors, is also discussed based on preliminary results. Early indication suggests that the photothermal approach is more sensitive than the thermomechanical one.     

刚体极限平衡法与有限元法在工程边坡稳定性分析中的应用与比较

刚体极限平衡法、有限元法在工程边坡稳定分析中是两个常用的计算方法,文中对两种方法的理论基础和计算过程进行了简要介绍,并应用两种方法对一工程实例进行了分析。结果表明,二者的计算结果相近,且相同工况下有限元计算安全系数略小于刚体极限平衡法计算安全系数。     

长春油田双阳组经济可采储量评价

选用经济极限含水率法和现金流通法对长春油田双阳组经济可采储量进行评价。对于前者,在前人研究的基础上结合已有经济参数及水驱曲线推导出经济极限含水率公式;对于后者,除重点预测产量及注水量外,还充分考虑操作成本、相关税费、不同原油价格等经济参数影响。两种方法的结合能有效地计算出长春油田双阳组经济可采储量,正确指导后期开发。     

免棱镜全站仪在桥梁检测中的应用

在公路桥梁施工过程中,每一项结构工程实体（桩、承台、柱）完成后,都要及时进行检测、验收.工作量大、危险性高、操作不方便,给工程检测工作带来很大的困难.本文结合几年来工程施工检测经验,利用免棱镜全站仪的功能,对实体工程中心坐标的检测和验收,提出了一种新方法,该方法简单,实用价值高,取得了良好经济效益.     

分布式集中供热微机控制系统

由供热站控制装置、温度巡测仪和ＰＣ－３８６微机构成对供热站及热用户的多种现场参数进行采集与控制。文中提出了一种根据补水进行前馈控制的方法。并给出了远距离测温探头的实际应用线路。     

某种新的高强度钢非线性品质的研究

根据比例极限定律，将材料拉伸试验数据进行曲线拟合，得到ＰＬＬ材料常数及相应的计算，误差分析说明该材料的非线性品质是稳定的，并可用ＰＬＬ的一个导出式来表达。